热门关键词:
DIN5481-2005德国花键标准翻译
  • 该文件为doc格式
  • 文件大小:32.00 KB
  • 下载次数
  • 文件评级
  • 更新时间:2017-12-12
  • 发 布 人15968699848
  • 文件下载:
  • 立即下载

  • 文件介绍:
  • 该文件为 doc 格式,下载需要 1 积分
  • DIN5481-2005德国花键标准翻译6 3 Symbols, designations and units 符号,职称和单位
    Symbols 符号
    Designation 指定
    Units 单位
    D pitch diameter 中径 mm
    Dee Tip diameter of shaft 提示直径轴 mm
    Dii tip diameter of hub提示直径枢纽



    7 4 Structure 结构
    Shaft serrations as in this standard have a constant space angle, ye=60°。The space angle of serrations on the corresponding hubs varies in relation to the number of teeth. The nominal tooth thickness is equal to half the pitch length on the specified pitch circle. 轴锯齿在这个标准有一个恒定的空间角度看,Υe= 60 ° 。空间角度锯齿相应的中心有所不同,有关齿数。名义齿厚等于一半的球场长度在指定的分度圆。
    5Diameters 直径
    5.1 General 一般
    The nominal diameters describe the rounded minor diameter of the hub and the major diameter of the shaft, respectively,e.g. 7x8. These diameters have tolerances A11 and a11,respectively. The pitch diameter on any one workpiece are roughly equal. The form circle is generated when the root diameter for the specified maximum radius is generated at a constant tooth thickness or space width(see Figure 2). 标称直径描述的圆形小直径的枢纽和大直径的轴,分别例如7x8 。这些直径有公差答11和解答11分别。在球场上任何一个直径工件的大致相等。循环的形式,产生的根源时,直径为指定的最大半径不断产生齿厚或空间宽度(见图2 ) 。
    Figure 2--Hub and shaft diameters 图2 -轮毂和轴直径
    5.2 Hub diameters 轮毂直径
    table 1 shows the standard hub diameters. 表1显示了标准枢纽直径。


    24. —11.4.1 GO plug gauges 往插件压力表
    Table 18 lists diameters of GO plug gauges 表18列出的GO直径插件压力表
    Table 18---Diameters of GO plug gauges 表18 ---直径往插件压力表
    Nominal diameter 标称直径
    Number of teeth 齿数
    Space angle 空间角度
    pitch diameter 中径
    Tip diameter 齿顶圆直径
    Tolerance tip diameter 尖端直径公差
    Root form circle diameter 齿根圆直径
    Root radius max 齿根圆最大圆弧半径...
文档留言
验证码: 请在右侧输入验证码 看不清楚,换一个